Ross Torr – Clean View Windows, Vic, Australia
“Would just like to say that we have owned a Quattrolifts Express 200CW which we bought from you approximately 6 weeks ago, this machine is better than you told us, as a Director of the business, I am always worried about OH&S and this machine lifts everything plus more! Also thanks very much for the after sales back up service you have given us, coming back to explain the machine to my staff was fantastic and they have all commented on what you showed them. Once again I am happy for you to show this to any of your customers in our area.”
Kym Wilson – Bayview Glazing QLD AUSTRALIA“Just wanted to give you some feedback on the lifter we purchased a couple of months ago. “Just a quick note to say what a great piece of equipment. As I am a glazier that has a buggered back and now confined to the shiny seat in the office I reckon if the Nomad was around 25 years ago I would still be glazing commercial. We have just done our first two reglazes both 12.38 laminate 2400 x 3400 aprox 1000 off the ground in a local shop front. Last time it took 3hrs and 6 men to reglaze 1 panel only including scaffold and back pain. This time 4 people and the Nomad, no scaffold and 2 panels took 1 hour including loading the old 12.38 lam on the truck!!!!!! Possibly could have used 3 people but being the first time, are to be sure to be sure! Instant success and the knockers are now believers!! We set a frame approx 2 mtrs square up in the factory and used a piece of 8.38 lam for practice and used 6 people to glaze the panel two times each as a training session before tackling possibly the biggest reglazes in town. Thanks for the quick delivery although the company colors were a little out, yellow was good but maroon turned out blue!!!!!!!!!!!!!! Only joking and again thanks for the prompt service and I will recommend this machine and your business anywhere anytime. Regards extremely happy” Kym Wilson
Matt Abbate – Golden Strip Glass – SC USA“We got 9 pcs set in about 5 hours of total work (doesn’t include setup time and testing out the first piece). The most important part is I got 9 pcs set without any broken backs or glass. They’ll be fresh and ready to set more tomorrow. FYI this glass is 1 1/16″ thick insulated units averaging about 50″ x 144″, 385 lbs, and about 40″ off the ground.” https://vimeo.com/88548130
Grant Woodorth – R&R Glass Services NSW AUSTRALIA“Just wanted to give you some feedback on the lifter we purchased a couple of months ago. So far we’ve completed 3 installations.
- Installation of a 12mm toughened sliding door with top and bottom rails, 2200 x 1880 – we used the quattro to get the glass off the A frame truck, up 5 floors in the lift, then hang the door on the overhead sliding door track without raising a sweat! We had installed 4 of these doors 3 months previously and it was heavy, streuous work, with all the lifting by hand and an extra man. I wish we had had it back when we did the original installation.
- Installation of a 12.38mm laminated shopfront panel 3100 x 1400. Once again the quattro made it easy to take delivery of the glass, wheel to the job, rotate the glass to it’s vertical position then install.
- Installation of 6 panels of 15mm toughened, 3100 x 1800. We had to supplement the quattro with a small crawler crane as the glass was the same height as the ceiling.